17.5 AC Through a Resistor
Alternating Current
A resistor R connected with an AC source is shown in Fig.17.6 (a). The instantaneous voltage V is given as:
The instantaneous current I through the circuit is:
Alternating Current
A resistor R connected with an AC source is shown in Fig.17.6 (a). The instantaneous voltage V is given as:
The instantaneous current I through the circuit is:
where Iₒ = Vₒ/R is the peak or maximum value of current.
It follows from Eqs.(17.10) and (17.11) that the instantaneous values of both voltage and current are sine functions which vary with time. Figure 17.6(b) shows that both voltage and current pass their minimum and maximum values at the same time and thus their instantaneous values are said to be in phase with each other.
Also Fig.17.6(c) shows V_R and I_R vectors for resistance. V and I are drawn parallel because there is no phase difference between them. The opposition to AC which the circuit presents is the resistance given by
The power dissipation is proportional to the square of the current and makes no difference whether the current is direct or alternating i.e., whether the sign associated with the current is positive or negative. However, the power dissipation produced by AC having maximum value Iₒ is not the same as that produced by a direct current of maximum value Iₒ, because the alternating current is at this maximum value only for an instant during each half-cycle. Instantaneous power P dissipated across a resistor in AC circuit is:
and average power
Also, it can be proved that;
It is to be noted that here P is measured in watts V in volts, I in amperes and R in ohms respectively, and the Eq.(17.12) for power holds good only when V and I are in phase.
A 1 kW heating element is connected to a 250 V AC supply voltage. Calculate the amount of current taken from the supply and the resistance of the element when it is hot.
Solution
Power P = 1 kW = 1000 W and
Applied voltage V = 250 V
We know that; P = VI or I = P/V
I = 1000 W / 250 V = 4 A
R = 250 V / 4 A = 62.5 Ω
Also V = IR which suggests that, R = V/I
R = 250 V / 4 A
R = 62.5 Ω