17.3 Phase of A.C.
Alternating Current
The angle θ which specifies the instantaneous value of the alternating voltage or current is called the phase. The instantaneous values of voltage and current are given by
Alternating Current
The angle θ which specifies the instantaneous value of the alternating voltage or current is called the phase. The instantaneous values of voltage and current are given by
The angle which gives the value of alternating quantity is known as phase.
The phase of points A, B, C, D and E are 0, π/2, π, 3π/2 and 2π respectively as shown in Fig.17.5(a), Thus each point of A.C cycle corresponds to a phase.
Referring to the Figs.17.5 (b) and 17.5(c), at t = 0, the angle θ is also 0°, the value of the phase angle θ at t equals to zero is called the initial phase of AC quantity. Thus, according to equations:
which correspond to Figs.17.5(b) and 17.5(c) respectively, the initial phase of both voltage V and current I is zero. There are situations when current I and voltage V are not in phase i.e; they differ in phase. For example, the initial phase of current I may be positive or negative as compared to the initial phase of voltage V, which is zero. Consider a situation in which the initial phase of voltage V is zero and initial phase of current I is φ as shown in Fig.17.5 (b). This situation can be represented by the following equations:
At t = 0; voltage V = 0, but the current is positive and I = Iₒ sin φ. It means that the current had its zero value earlier by an angle φ than voltage. Thus, we can say that the current is leading the voltage by an angle φ in this situation (Fig. 17.5-b). The angle φ is the phase difference between the voltage and the current.
Similarly, the initial phase of current I is negative as compared to the initial phase of voltage V, which is zero as shown in Fig.17.5(c). This situation can be represented by the following equations:
It means the value of V is zero, but the current I has some negative value (I – sin φ). It means that the current I will reach its zero value later on by an angle φ than the voltage V. Thus, we can say that current I is lagging behind the voltage V by an angle φ. The angle φ is called the phase difference between V and I.
An alternating quantity can be represented by an anticlockwise rotating vector if it satisfies the conditions: (i) Its length on a certain scale represents the peak value or rms value of alternating quantity. (ii) It is in horizontal position at the instant. When the alternating quantity is zero and is increasing positively (iii) The angular frequency of the rotating vector is same as the angular frequency of alternating quantity.
Fig.17.5 (d) shows an alternating voltage waveform leading the current wave form by 90° or π / 2 rad. In Fig.17.5(e), vector OI represents peak or rms value of current which is taken as reference quantity. Similarly, OV represents peak or rms value of alternating voltage, which is leading the current by π/2 rad or 90°. Both vectors are rotating in anticlockwise direction with angular frequency.