28.3 Thin-Layer Chromatography
Chromatography
In thin layer chromatography (TLC), alumina (Al₂O₃) or silica (SiO₂) is mixed in water to make slurry which is then spread evenly onto a glass slide. This layer is dried in an oven to make a white solid layer (stationary phase) on the glass slide. TLC is faster than paper chromatography.
A straight baseline is drawn by pencil and ruler near the bottom of the glass slide. A spot of sample is put on the baseline by the capillary tube. More than one samples can be spotted at different places on the same glass slide. The solvent is taken in a chromatography tank. The glass slide is dipped in the solvent (mobile phase) in such a way that baseline is above solvent level.
The components present in the sample dissolve in the solvent and adsorb onto aluminium oxide differently. Some are more soluble in the mobile phase while some are more adsorbed onto the solid stationary phase. Polar substances have greater attraction for polar solid stationary phase and are adsorbed more strongly. Therefore, they travel more slowly up the stationary phase. On the other hand, non-polar substances are more soluble in the non-polar solvent, and they move more up the slide. This difference allows the substances in the sample to separate. After the solvent has moved up to a certain height, the glass slide is removed from the chromatographic chamber. Solvent front, the highest point reached by the solvent, is marked. The glass slide is dried by dryer. Rf values of different coloured spots are calculated. By comparing these Rf values with standard values, the components present in the sample are identified. Sometime the components are colourless, locating agent is sprayed to visualise them. Ninhydrin spray give purple colour to colourless amino acids. Some colourless substances glow when irradiated with ultra-violet light while some turn brown with iodine vapours.